 |
|
Image_to_Pos
Image_to_Pos
Input
port. It is designed to give the user a wide variety of image
sizes, orientations, postitions, and qualities. Note that the Dump
to File button must be pressed to dump the image to the file, as the
dump may take several seconds (see under parameters).
The Inputs:
----------
Input Field: Field 2D Uniform 4-Vector Byte - The image to be
printed
The Outputs:
-----------
None (File output)
The Parameters:
--------------
Filename : The file to which the postscript output is sent - .ps is
NOT added
Bit Per Component : This is the number of bits per component per pixel.
Note that if, for example, 4 Bits is selected, then the total
number of bits per pixel will be 4, 12, or 16, depending on
the setting of Color/Grayscale. The more bits per component
per pixel, the higher the image quality, and the larger the
image file.
Color/Grayscale : This selects the type of image to be drawn to the
PS file. Grayscale is graylevels, 3 color is Red-Green-Blue,
and 4 color is Cyan-Magenta-Yellow-Black. 4 color images
will often look better than 3 color images, if printed to
a 4 color printer. They will look no different if sent to
a 3 color printer.
Orientation : The orientation of the image
Left Position : The horizontal distance from the left edge of the
page, when viewed with the image correct-side up.
Bottom Position : The vertical distance from the bottom edge of the
page, when viewed with the image correct-side up.
Width : The horizontal width of the image, when viewed with the image
correct-side up.
Dump to File : Actually dumps the current image to the desired file
Example network
---------------
Read Image
|
|
Image to Postscript
Known Problems/Bugs/Limitations:
-------------------------------
A version that tiles 4 images automatically has been written, but
is not yet stable enough for release.
No Autosizing of the image yet.
The module is unable to store actual printer page sizes
Rather Slow.
|
|